Upgrading everyday security Commpact Manuel d'utilisateur télécharger pdf (Page 38)

2 In the Setup Type wizard, select one of the following options:

Complete.

Custom.

From the VMware Device Drivers list, select VMCI Driver, then select NSX Driver.

Install Data Security

Prerequisites

vShield Endpoint must be installed on the cluster where you are installing Data Security.

If you want to assign an IP address to the Data Security service virtual machine from an IP pool, create the

IP pool before installing Data Security. See “Create an IP Pool,” on page 39.

Procedure

1 Click Networking & Security and then click Installation.

Click the Service Deployments tab and click the New Service Deployment (

) icon.

3 In the Deploy Network and Security Services dialog box, select Data Security and click Next.

4 In Specify schedule (at the bottom of the dialog box), select Deploy now to deploy Data Security as

soon as it is installed or select a deployment date and time.

5 Click Next.

6 Select the datacenter and cluster(s) where you want to install Data Security and click Next.

7 On the Select storage page, select the datastore on which to add the service virtual machines storage or

select Specified on host.

The selected datastore must be available on all hosts in the selected cluster.

If you selected Specified on host, the datastore for the ESX host must be specified in the AgentVM

Settings of the host before it is added to the cluster. See vSphere API/SDK Documentation.

8 Click Next.

9 On the Configure management network page, select the distributed virtual port group to host the

management interface. This port group must be able to reach the NSX Manager’s port group.

If the datastore is set to Specified on host, the network to be used must be specified in the

agentVmNetwork property of each host in the cluster. See vSphere API/SDK Documentation.

When you add a host(s) to the cluster, the agentVmNetwork property for the host must be set before it

is added to the cluster.

The selected port group must be available on all hosts in the selected cluster.

10 In IP assignment, select one of the following:

Select To

DHCP

Assign an IP address to the Data Security service virtual machine through

Dynamic Host Configuration Protocol (DHCP).

An IP pool

Assign an IP address to the Data Security service virtual machine from the

selected IP pool.

Note that static IP address are not supported.

11 Click Next and then click Finish on the Ready to complete page.

NSX Installation and Upgrade Guide

38 VMware, Inc.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 57 58

Pas de commentaire

Upgrading everyday security Commpact Manuel d'utilisateur Page 38