Upgrading everyday security Commpact Manuel d'utilisateur télécharger pdf (Page 30)

In NSX Edge Appliances, click the Add ( ) icon to add an appliance.

If you had selected Enable HA on the Name and Description page, you can add two appliances. If you

add a single appliance, NSX Edge replicates its configuration for the standby appliance and ensures that

the two HA NSX Edge virtual machines are not on the same ESX host even after you use DRS and

vMotion (unless you manually vMotion them to the same host).

5 In the Add Edge Appliance dialog box, select the cluster or resource pool and datastore for the

appliance.

6 (Optional) Select the host on which the appliance is to be added.

7 (Optional) Select the vCenter folder within which the appliance is to be added.

8 Click OK.

9 Click Next.

The Interface Configuration page appears.

Add Internal and Uplink Interfaces

You can add up to ten (internal and uplink) interfaces to an NSX Edge virtual machine.

Procedure

On the Configure Interfaces page, click the Add (

) icon and type a name for the interface.

2 Type a name for the interface.

3 Select Internal or Uplink to indicate whether this is an internal or external interface.

NOTE You must add at least one internal interface for HA to work.

4 Select the port group or logical switch to which this interface should be connected.

a Click Select next to the Connected To field.

b Depending on what you want to connect to the interface, click the Logical Switch, Standard

Portgroup, or Distributed Portgroup tab.

c Select the appropriate virtual wire or portgroup.

d Click Select.

5 Select the connectivity status for the interface.

In Configure Subnets, click the Add ( ) icon to add a subnet for the interface.

NOTE An interface can have multiple non-overlapping subnets.

In Add Subnet, click the Add (

) icon and type IP address for the subnet.

NOTE If you enter more than one IP address, you can select the Primary IP address. An interface

can have one primary and multiple secondary IP addresses. NSX Edge considers the Primary IP

address as the source address for locally generated traffic.

You must add an IP address to an interface before using it on any feature configuration.

b Type the subnet mask for the interface and click OK.

NSX Installation and Upgrade Guide

30 VMware, Inc.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 57 58

Pas de commentaire

Upgrading everyday security Commpact Manuel d'utilisateur Page 30